DODGE

08-075-25 REV. C

2025-12-18 · NHTSA 11026771

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

RSU With Additional Sleep Cycles for HV Battery Integrity Check - Flash: Electronic Vehicle Control Unit (EVCU) Updates 11B3 Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **B12B4-00 - Charge Status Indicator Module Internal.** ● C10FA-00 - Wheel Hub disconnect Actuator Performance Left. ● C10FB-00 - Wheel Hub disconnect Actuator Performance Right. ● C10F8-00 - Left Front Wheel Hub Disconnect Actuator Position Sensor Circuit Range/Performance. ● C10F9-00 - Right Front Wheel Hub Disconnect Actuator Position Sensor Circuit Range/Performance. ● P061B-00 - Internal Control Module Torque Calculation Performance. Customers may also comment on one or more of the following: ● **Loss of communication between EVCU and the Battery Pack Control Module (BPCM) can prevent high-voltage contactors from closing, resulting in a no-start condition. ● Remote start functionality fails when the vehicle is actively charging. ● "Charge Now" feature in application has multiple issues. Feature intermittently fails and does not close contactors, sometimes starts but charge port indicator lights are not commanded by EVCU and sets DTC B12B4-00. ● Closed loop 12V silent charging which can help mitigate a 12V drain issue on the vehicle. ● Drive-by-brake improvements and a resolved issue where the vehicle incorrectly enters turtle mode while driving. ● Powershot sometimes stuck at 0 seconds remaining which makes customer believe that Powershot is not working. ● Wheel End Disconnect closure at zero speed in case of miss at normal close speed. ● Drive-by-brake message update to Instrument Panel Cluster (IPC) in case of Limp Home mode. ● Vehicle will not start due to depleted 12v battery. ● Improvements to minimize occurrences of Limp Home Mode (Turtle Mode)** ● IPC, radio range and charge time estimations and messages are not correct. ● Battery range incorrect. ● Improved battery State of Charge (SoC) accuracy in off-nominal conditions. ● Battery heating values incorrect on radio when on Performance Pages display. ● Charging does not start when plugged in. ● Charging is not indicating when battery is at full charge. ● Charging slow or takes too long. ● Bumps and jerks while accelerating or decelerating. ● Wrench icon is illuminated on the IPC This bulletin involves reprogramming the IDCM, BPCM, MCP A, MCP B and the EVCU with the latest available software and then, if needed, performing a Wheel End Disconnect Position Learn routine

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。