MERCEDES-BENZ

LI47.70-P-079912

2026-09-29 · NHTSA 11038189

车型关联可作为查阅线索；具体发动机、生产范围和软件条件请核对厂商资料。

厂商摘要

以下为英文原文

Complaint Vehicle will not start after DC charging Warning in the instrument cluster related to High‐voltage on board electrical system The following fault codes related to stuck contactor can be found in the High Voltage Control units : PTCU ‐ N127 (Powertrain control unit) • P154900 ‐ There is a warning due to overcurrent in the charging system of the high‐voltage electric circuit. • P154A00 ‐ There is a warning due to a detected crash event at standstill. • P154B00 ‐ There is a warning due to a stuck contactor. DCB223 ‐ N116/5 (Direct current charge connection unit) • P0E8929 ‐ The input current of the on‐board DC charging connection unit is too high. There is an invalid signal. • P2BC500 ‐ The contact ''Positive terminal'' of the contactor in the on‐board DC current charge‐connection unit is jammed closed • P2BCC00 ‐ The contact ''Negative terminal'' of the contactor in the onboard DC current charge‐connection unit is jammed closed. Instrument cluster warning messages : Cause • Current ripple due to EVSE (Electric Vehicle Supply Equipment) • Overcurrent or Overvoltage due to EVSE (Electric Vehicle Supply Equipment) • DCB contactors did not open immediately due to welding time at the end of DC charging Remedy • Check for a new software availability for DCCU (N116/5 ‐ Direct Current Charge connection Unit). If a new software is available, update the software first. • Reset contactor fault through special procedure without password. ( N116/5 >> Special Procedure >> Resetting of contactor fault.) Important Note : • Do not replace component DCB (N116/5) • If fault codes are not erasable, please raise a TIPS case and send it to HQ.

仅当厂商、通报编号、发布日期和完整摘要一致时，重复登记才会合并展示，原始编号仍予保留。旧资料继续供查阅；确认明确替代关系后才标示后续版本。1994 年以前的车辆关联与默认结果分开显示；未注明年款不等于适用于所有年款。