查看

P2804 · 厂商技术资料

车型关联可作为查阅线索;具体发动机、生产范围和软件条件请核对厂商资料。

P2804 ← 这个码是什么意思?

3 结果

SSM 49822 ↗

FORD · 2021-05-24

Some 2020-2021 F-Super Duty vehicles equipped with an 10R140 automatic transmission may exhibit an illuminated malfunction indicator Lamp (MIL) and/or powertrain malfunction indicator (wrench) lamp with various transmission fluid temperature (TFT) and/or transmission range (TR) sensor diagnostic trouble codes (DTC) P2805, P0706, P0707, P0708, P0709, P2801, P2802, P2803, P2804, P0710, P0711, P0712, P0713 and/or P1711 stored in the powertrain control module (PCM) or the transmission control module (TCM). If any of these DTCs are present, disconnect the transmission vehicle harness connector C168A, and if equipped, the TCM connector C1750 to inspect for damaged or pushed out terminals, corrosion, loose wires and missing/damaged seals. If damage is found, repair as necessary. If no issues are…

SSM 49510 ↗

FORD · 2021-01-29

Some 2020-2021 Transit vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with all of the following diagnostic trouble codes (DTCs) stored in the powertrain control module (PCM): P2804, P2803, P0713, P0710, P0709, and P0708. This article only applies if all of these DTCs are present. Prior to any diagnosis, inspect connectors C1551, C1280, C1281, and C1520 for partial connections, damage, or pushed out pins and repair as necessary. If a fault is not identified during the inspections of the connectors, continue diagnosis using the appropriate WSM Sections.

SSM 49242 ↗

FORD · 2020-10-07

Some 2020 Transit vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with all of the following diagnostic trouble codes (DTCs) stored in the powertrain control module (PCM): P2804, P2803, P0713, P0710, P0709, and P0708. This article only applies if all of these DTCs are present. Prior to any diagnosis, inspect connectors C1551, C1280, C1281, and C1520 for partial connections, damage, or pushed out pins and repair as necessary. If a fault is not identified during the inspections of the connectors, continue diagnosis using the appropriate WSM Sections.