FCA

05047457A

2015-05-02 · NHTSA 10148872

車型關聯可作查閱線索；引擎、生產範圍與軟體條件請核對原廠資料。

原廠摘要

以下為英文原文

Multi-Air actuator assembly When attempting to diagnose P Codes related to the MultiAir Unit, please note that there are multiple causes listed for each in the diagnostic procedure. This procedure must be followed to ensure the correct condition is being addressed. ~ Please verify the following (listed as the first step in diagnosis) is not present before attempting repair:~ - LOW ENGINE OIL - INCORRECT OIL FILTER THAT DOES NOT MEET OEM SPECIFICATIONS - OIL DIRTY OR DETERIORATED (Lack of scheduled oil changes) - INCORRECT OIL VISCOSITY AND WEIGHT - ENGINE OIL CONTAMINATED (i.e., coolant and/or fuel)~ If Multi-Air actuator assembly part numbers 05047457AE or 05047980AA are being ordered/replaced for Check Engine Lamp On and DTC P1037, P103A, P103D or P1040 (Cylinder X Oil Supply Valve Short To Ground) on an ED6 (2.4L Multi-Air) equipped vehicle.~ 1) Disconnect the PCM connector harness and connect the Miller breakout tool (Adapter, GPEC Diagnostic 10436) to connector C2 of the PCM.~ 2) Measure resistance across each set of the VVA solenoid signal/return pins on the module (pins 26&27, 1&25, 2&3 and 4&5).~ 3) If each of the resistance readings is above 10K ohm (should measure around 15K ohm), the PCM is good.~ 4) If any resistance reading is below 10K ohm, then the PCM is damaged and should be replaced instead of the Multi-Air actuator assembly.

僅在原廠、通報編號、發布日期和完整摘要一致時，才合併重複登錄，並保留原始編號。舊資料仍可查閱；確認明確取代關係後才標示後續版本。1994 年以前的車輛關聯與預設結果分開顯示；未註明年式不等於所有年式適用。