JEEP

9100439

2024-10-30 · NHTSA 11009542

車型關聯可作查閱線索；引擎、生產範圍與軟體條件請核對原廠資料。

原廠摘要

以下為英文原文

MODULE Steering Control Before replacing the steering column control module (SCCM) due to front or rear windshield wiper operation / blindspot inop / lane assistant inop/ DTC B178F-15 active, please follow these steps: 1.- Refer to TSB-08-219-24 MP - Rear Windshield Wipers Operate Continuously and TSB 08-136-24 REV. A - Adaptive Cruise Control (ACC) Module Update. 2.- Verify if failure is still present (review wipers, turn signal, blindspot and lane assistant status) and if DTCs still active. 3.- If failure still present, make sure all the switches' and airbag's harness are properly connected and there is no corrosion, disconnect the switches & reconnect them, and reverify the issue. 4.- Read at the BCM diagnosis session if BCM is receiving information from SCCM. Through diagnosis review if activation from wipers is requested, if turn signal, blindspot and lane assistant work. 5.- Do a hard reset of battery to BCM and evaluate if any DTC is set. Retest if failure still present. If there are no DTC's, physical defects, wipers inop, nor turn signal inop, then SCCM does not need to be replaced.

僅在原廠、通報編號、發布日期和完整摘要一致時，才合併重複登錄，並保留原始編號。舊資料仍可查閱；確認明確取代關係後才標示後續版本。1994 年以前的車輛關聯與預設結果分開顯示；未註明年式不等於所有年式適用。