查看

MERCEDES-BENZ

LI42.45-P-079407

2025-06-12 · NHTSA 11019637

車型關聯可作查閱線索;引擎、生產範圍與軟體條件請核對原廠資料。

原廠摘要

以下為英文原文

Complaint Instrument cluster warning lamp and/or warning message for brake system, EPB, ESP (yellow or red) and possibly 12 V battery (red) Different combinations of the following DTCs present in the ESP: B23AA77, B23AB77, B23D177 and in part (C100BE0, C100BE1, B23AA1B, B23D152) Cause Due to a reduction in resistance at the HV voltage divider, the DC/DC converter measures an incorrect HV voltage. Regulation of the 12 V output voltage therefore becomes unstable. I.e. the output voltage starts to fluctuate and the output current starts to jump instead of slowly regulating to the currently requested value. The EPB position is calculated by the voltage and the current. Since these fluctuate, the ESP control unit loses its position and sets the DTCs. Remedy Check of the DC/DC converter via XENTRY Diagnosis: • Compare the serial number of the DC/DC converter with a list of potentially affected parts in XENTRY -> DC/DC converter N83/1 -> Special Processes. • If the evaluation comes back as defective - Replace the DC/DC converter and inspect the EPB for Subsequent complaint, defect. • If the evaluation comes comes back not affected: Actuate BUCK mode for approx. 30 s • The output current normally jumps to a high value (e.g. 100 A) and then falls slowly to the current specified value e.g. 50 A and then only changes slowly and in small increments. • In the event of this fault cause, the output current is subject to strong fluctuations/jumps (multiple 1-10 A) (see videos in attachment). • In the event of strong fluctuations and the S/N not identified in the Special Process, please open a TIPS case and attach print out of DC/DC special procedure and buck mode actual values. Subsequent complaint, defect on the EPB: • Check of the actuators and brake caliper piston • Manually extend and retract the piston on the brake caliper completely using the suitable socket • If the piston sticks at a certain point, the rotation force increases significantly • If the brake caliper piston sticks, the brake caliper has to be replaced • If the retaining ring of the actuator is broken, the actuator has to be replaced • In XENTRY, edit the stored test instructions of the remaining DTCs

NHTSA 原廠通報資料 ↗

僅在原廠、通報編號、發布日期和完整摘要一致時,才合併重複登錄,並保留原始編號。舊資料仍可查閱;確認明確取代關係後才標示後續版本。1994 年以前的車輛關聯與預設結果分開顯示;未註明年式不等於所有年式適用。