P0708 · 原廠技術資料

FORD · 2021-09-27

Some 2021 Bronco Sport vehicles built on or before 01-Aug-2021 may exhibit a shift system fault warning displayed in the instrument panel cluster (IPC). The vehicle may also exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P0708, P0709, P2803, 2804 and/or P07E6 in the powertrain control module (PCM). This may be due to software calibration. To correct the condition, follow the Service Procedure to reprogram the PCM.

FORD · 2021-05-24

Some 2020-2021 F-Super Duty vehicles equipped with an 10R140 automatic transmission may exhibit an illuminated malfunction indicator Lamp (MIL) and/or powertrain malfunction indicator (wrench) lamp with various transmission fluid temperature (TFT) and/or transmission range (TR) sensor diagnostic trouble codes (DTC) P2805, P0706, P0707, P0708, P0709, P2801, P2802, P2803, P2804, P0710, P0711, P0712, P0713 and/or P1711 stored in the powertrain control module (PCM) or the transmission control module (TCM). If any of these DTCs are present, disconnect the transmission vehicle harness connector C168A, and if equipped, the TCM connector C1750 to inspect for damaged or pushed out terminals, corrosion, loose wires and missing/damaged seals. If damage is found, repair as necessary. If no issues are…

FORD · 2021-01-29

Some 2020-2021 Transit vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with all of the following diagnostic trouble codes (DTCs) stored in the powertrain control module (PCM): P2804, P2803, P0713, P0710, P0709, and P0708. This article only applies if all of these DTCs are present. Prior to any diagnosis, inspect connectors C1551, C1280, C1281, and C1520 for partial connections, damage, or pushed out pins and repair as necessary. If a fault is not identified during the inspections of the connectors, continue diagnosis using the appropriate WSM Sections.

FORD · 2020-10-07

Some 2020 Transit vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with all of the following diagnostic trouble codes (DTCs) stored in the powertrain control module (PCM): P2804, P2803, P0713, P0710, P0709, and P0708. This article only applies if all of these DTCs are present. Prior to any diagnosis, inspect connectors C1551, C1280, C1281, and C1520 for partial connections, damage, or pushed out pins and repair as necessary. If a fault is not identified during the inspections of the connectors, continue diagnosis using the appropriate WSM Sections.

HYUNDAI · 2019-11-15

If you are servicing a vehicle with the DTC or symptoms listed below, refer to the Service Procedure to diagnose the condition. ? Diagnostic trouble codes: ?P0705 - Range switch sensor circuit ?P0706 - Range switch range/performance ?P0707 - Range switch - open circuit ?P0708 - Range switch - short circuit or multiple inputs ? Symptoms: ?Malfunction Indicator Light (MIL) illuminated ?4th gear fail-safe ?No gear indication in cluster ?Intermittent no engine crank/no start in ?P? or ?N? with or without MIL or DTC.

HYUNDAI · 2017-08-03

If you are servicing a vehicle with the DTC or symptoms listed below, refer to the Service Procedure to diagnose the condition. ? Diagnostic trouble codes: ? P0705 - Range switch sensor circuit ? P0706 - Range switch range/performance ? P0707 - Range switch - open circuit ? P0708 - Range switch - short circuit or multiple inputs ? Symptoms: ? Malfunction Indicator Light (MIL) illuminated ? 4th gear fail-safe ? No gear indication in cluster ? Intermittent no engine crank/no start in ?P? or ?N? with or without MIL or DTC.

ALLISON · 2016-01-21

Customer may experience the truck not starting and an active DTC P0708 Transmission Range Sensor Circuit ? High Input.

HYUNDAI · 2013-10-01

HYUNDAI: DUE TO AN IMPROPERLY ADJUSTED OR IMPROPERLY OPERATING INHIBITOR SWITCH (RANGE SWITCH), ON SOME VEHICLES, RESULTED IN RANGE SWITCH SENSOR CIRCUIT (P0705), OPEN CIRCUIT (P0707), SWITCH RANGE/PERFORMANCE (P0706), SHORT CIRCUIT OR MULTIPLE INPUTS (P0708), IMPOSSIBLE ENGINE START (P OR N), MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATION. MODEL 2010-2013 SANTA FE, TUCSON, SONATA, ELANTRA, AZERA, ACCENT, VELOSTER TURBO. *PE

HYUNDAI · 2009-07-01

HYUNDAI: AUTOMATIC TRANSAXLE RANGE SWITCH DIAGNOSTIC TROUBLE CODES P0705 (RANGE SWITCH SIGNAL PROBLEMS), P0707 (RANGE SWITCH OPEN CIRCUIT), AND P0708 (RANGE SWITCH SHORT CIRCUIT OR MULTIPLE INPUTS). AN IMPROPERLY ADJUSTED OR IMPROPERLY OPERATING RANGE SWITCH MAY RESULT IN THE ABOVE MENTIONED CONDITIONS. MALFUNCTION INDICATOR LIGHT (MIL) ILLUMINATED; IMPOSSIBLE ENGINE START IN P OR N. *PE

HYUNDAI · 2006-10-01

AUTOMATIC TRANSAXLE DTC P0708. *KB

UNKNOWN · 2005-03-01

AUTOMATIC TRANSAXLE RANGE SWITCH, DIAGNOSTIC TROUBLE CODES (DTCS) P0705, P0707 & P0708. KIA SEDONA. *TT

CHEVROLET, GMC · 2004-06-01

SLOW OR NO ENGAGEMENT OF AUTOMATIC TRANSMISSION NO START BLANK PRNDL DISPLAY FLASHING PRNDL DIAGNOSTIC TROUBLE CODE P0708 P0872 P0847 P0875 P1711 P1713 OR U1000 SET. THIS SERVICE BULLETIN REPLACES 020730011. *EH

HYUNDAI · 2003-07-01

AUTOMATIC TRANSAXLE RANGE SWITCH DIAGNOSTIC TROUBLE CODES P0705, P0707, P0708. *TT

CHEVROLET, GMC · 2003-03-07

MULTIPLE DIAGNOSTIC TROUBLE CODES, INCLUDING ANY OR ALL OF P0708, P0847, P0872, P0875, P1711 OR P1713, PARTIAL OR NO PRINDEL DISPLAY OR NO MOVEMENT. *TT *JB

CHEVROLET, GMC · 2002-05-01

SOME CUSTOMERS MAY COMMENT OF HARSH OR DELAYED 2-1 DOWNSHIFT, NEUTRAL FEEL AT A STOP, SHIFT BUSYNESS, DIAGNOSTIC TROUBLE CODES P0708, P0847, P0872, P0875, P1711, P1713 FROM 3/4 AND 1 TON PICKUP MODELS. *TT

HYUNDAI · 2001-07-01

SUBJECT REGARDING AUTOMATIC TRANSAXLE RANGE SWITCH DIAGNOSTIC TROUBLE CODES P0705,P0707,P0708. *YH

MAZDA · 1998-12-23

SUBJECT ON MIL ILLUMINATION WITH DTC'S P0705, P0708, P1704, AND/ OR P1705. *YC

FORD, LINCOLN, MERCURY · 1998-11-23

ISSUES REGAREDING DIAGNOSTIC TROUBLE CODES ( DTCS ) P0705, P0708, P1704, AND / OR P1705 MAY BE STORED IN MEMORY. *YC