U3000 · نشرات الشركة المصنعة

CADILLAC, CHEVROLET, GMC · 2026-09-21

This preliminary information communicates an issue with a service column lock message and DTC U3000. Engineering is working on the issue and in the meantime dealerships are to reset/clear the DTC and perform four sleep cycles to verify the DTC does not return.

FORD, LINCOLN · 2026-09-15

Some 2025 Aviator/Explorer/Police Interceptor Utility vehicles may exhibit a "Steering Assist Fault Service Required" message and diagnostic trouble codes (DTC) C1110:56 and/or U3000:96 stored in the power steering control module (PSCM) after programming. This may be due to a calibration mismatch in the PSCM which has been resolved in the Ford database. If DTC C1110:56 is stored in a replacement PSCM after completing programmable module installation (PMI), start a new session using the latest software version of the Ford Diagnosis and Repair System (FDRS) scan tool then run the "PSCM - Programmable Module Installation (PMI)" application again. When FDRS asks if the original module is installed, select "No". If DTC C1110:56 is stored in the original PSCM after performing the PSCM…

FORD · 2026-09-03

This bulletin updates 26-2206. Reason for update: update the Service Procedure to revise Steps 19-21, adding Step 22, and adding Figure 15-16 to clarify connector C316 location. Some of the vehicles listed in the Model statement above may exhibit diagnostic trouble codes (DTCs) C1001:31, U3000:89, and/or U3000:49 stored in the image processing module A (IPMA) and at least one of the following conditions: "Front Camera Fault Service Required" message Pre-collision assist inoperative Adaptive cruise control inoperative Front windshield camera alignment routine fails to complete This may be due to the coaxial cable between the IPMA camera and the IPMA.

BUICK, CADILLAC, CHEVROLET, GMC · 2026-05-11

This PI states that if SDGM DTC U3000 Sym 49 is set and no other SDGM DTCs are present, clear DTCs and reset the SDGM. Advises of how to contact PQC to authorize SDGM replacement.

FORD · 2026-05-01

This article updates TSB 23-2146. Reason for update: clarify prior approval requirements Some of the vehicles listed in the Model statement above may exhibit diagnostic trouble codes (DTCs) C1001:31, U3000:89, and/or U3000:49 stored in the image processing module A (IPMA) and at least one of the following conditions: "Front Camera Fault Service Required" message Pre-collision assist inoperative Adaptive cruise control inoperative Front windshield camera alignment routine fails to complete This may be due to the coaxial cable between the IPMA camera and the IPMA.

FORD · 2026-04-30

This article supersedes TSB 26-2021. Reason for update: to clarify prior approval requirements in the Service Procedure. Some of the vehicles listed in the Model statement above may exhibit diagnostic trouble codes (DTCs) C1001:31, U3000:89, and/or U3000:49 stored in the image processing module A (IPMA) and at least one of the following conditions: "Front Camera Fault Service Required" message Pre-collision assist inoperative Adaptive cruise control inoperative Front windshield camera alignment routine fails to complete This may be due to the coaxial cable between the IPMA camera and the IPMA.

FORD · 2026-01-31

This article supersedes TSB 25-2156 to update the Service Procedure and Labor Time Allowance. Some of the vehicles listed in the Model statement above may exhibit diagnostic trouble codes (DTCs) C1001:31, U3000:89, and/or U3000:49 stored in the image processing module A (IPMA) and at least one of the following conditions: "Front Camera Fault Service Required" message Pre-collision assist inoperative Adaptive cruise control inoperative Front windshield camera alignment routine fails to complete This may be due to a connection issue between the IPMA Camera and the IPMA.

MAZDA · 2026-01-13

If the right-side Blind Spot Monitoring (BSM) control module is replaced for any reason, it is also necessary to replace the left-side BSM control module in order to complete the radar aiming procedure. If the right-side BSM control module is replaced alone, "Automatic Configuration" and "BSM Radar Aiming" cannot be completed due to a programming error in the module. In most cases, if the left-side BSM control module is replaced alone, "Automatic Configuration" and "BSM Radar Aiming" can be completed without any problem (See CAUTION below for more details). Other possible symptoms that may be found if the right-side BSM module is replaced alone: BSM aiming fails “BSM OFF" indicator ON Center Display warning message BSM failsafe (No operation) DTC U3000:54 stored in memory DTC U1A4B:54…

FORD, LINCOLN · 2025-11-25

Some 2025 Aviator/Explorer/Police Interceptor Utility vehicles may exhibit diagnostic trouble code (DTC) C1110:56 and/or U3000:96 stored in the power steering control module (PSCM) after programming the PSCM, or may display the following message in Ford Diagnosis and Repair System (FDRS) when performing PSCM programmable module installation (PMI): <br /><br /> "It has been detected that a Model Year 2025 Steering Gear (R1MC - level) is fitted to this vehicle. It is not possible to run the Power Steering Control Module (PSCM) Programmable Module Installation (PMI) application on this Steering Gear. If later software is available, this PSCM can be updated by running the PSCM Software Update application."<br /><br /> This may be due to the calibration in the PSCM. When installing a…

MACK · 2025-11-11

CBR - Center Chassis Input Output Module(CCIOM) Fault Code U3000-94 - PR(4)

VOLVO · 2025-11-11

CBR - Center Chassis Input Output Module(CCIOM) Fault Code U3000-94 - VN (4).

FORD, LINCOLN · 2025-10-24

This article supersedes TSB 25-2104 to update the labor times associated with the Service Procedure. Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: * Inoperative BlueCruise and lane centering * DTC U2018:51 stored in the camera module - rear (CMR) * DTC U0565:86 stored in the image processing module A (IPMA) * DTC U3000:49 is not stored in the CMR This may be due to the software in the CMR.

FORD · 2025-10-01

This article supersedes TSB 23-2280 to update labor times from M-time to fixed time. Some vehicles listed in the Model statement above, may exhibit an illuminated airbag warning indicator with diagnostic trouble codes (DTCs) U3000:41 and/or U3000:54 in the occupant classification system module (OCSM) and/or B00A0:09, B00A0:63, B00A0:64 and/or B00A0:68 in the restraints control module (RCM).

BUICK, CADILLAC, CHEVROLET, GMC · 2025-09-27

This Preliminary information communicates not to replace the Image processing Module if the following DTC's are history - U3000 SYM49, U1624, U0140, U023B SYM00, U053C, B1DD SYM57.

FORD · 2025-09-10

Some of the vehicles listed in the Model statement above may exhibit an inoperative Blue Cruise and Lane Keeping system with diagnostic trouble code (DTC) U3000:49 with a status byte of 8F stored in the camera module-rear (CMR). This may be due to the CMR software level. NOTE: The driver status monitor camera module may also be called camera module-rear.

BUICK, CADILLAC, CHEVROLET, GMC · 2025-09-08

This Preliminary information communicates not to replace the Image processing Module if the following DTC's are history - U3000 SYM49, U1624, U0140, U023B SYM00, U053C, B1DD SYM57.

MACK · 2025-08-08

CBR - The purpose of this CBR is to provide instructions when fault code U300056: Electronic Control Unit, Invalid/Incompatible Configuration for the RCIOM is active.

VOLVO · 2025-08-04

CBR - The Purpose of this CBR is to assist with diagnostics for fault code U300049 on the Battery Power Management Unit (BPMU).

VOLVO · 2025-07-22

CBR - The Purpose of this CBR is to assist with diagnostics for fault code U300049 on the Battery Power Management Unit (BPMU).

FORD · 2025-07-21

Some 2022-2024 Mustang Mach-E vehicles may exhibit an inoperative BlueCruise and lane centering with diagnostic trouble code (DTC) U3000:49 stored in the camera module rear (CMR). This may be due to the software level of the CMR. Inform customers that engineering is currently working on a solution for this condition that is expected in Q3 2025. Monitor Professional Technician System (PTS) for additional information.

CADILLAC, CHEVROLET, GMC · 2025-06-12

This PI involves DTC U3000 SYM49 Set falsely In The Serial Data Gateway Module and dealerships are to reset the module by cycling the battery.

CADILLAC, CHEVROLET, GMC · 2025-05-30

This Preliminary information communicates with dealers if they see a Service 4WD Message on with DTC U3000 SYM47 and/or SYM49 set in the TCCM, Check DTCs, Clear DTCs and advise customer engineering is working on a design improvement.

CADILLAC · 2025-05-09

This Preliminary information communicates not to replace the Image processing Module if the following DTC's are history - U3000 SYM49, U1624, U0140, U023B SYM00, U053C, B1DD SYM57.

VOLVO · 2025-05-08

This CBR solution provides guidance for addressing the U3000-05 fault code in theWireless Sensor GateWay (WSGW) following the S4312 Service Campaign.

FORD · 2025-04-27

This article supersedes TSB 23-2155 to update the Service Procedure and change labor operation from actual time to fixed time. Some of the vehicles listed in the Model statement above may exhibit diagnostic trouble codes (DTCs) C1001:31, U3000:89, and/or U3000:49 stored in the image processing module A (IPMA) and at least one of the following conditions: "Front Camera Fault Service Required" message Pre-collision Assist inoperative Adaptive cruise control inoperative Front windshield camera alignment routine fails to complete This may be due to a connection issue between the IPMA Camera and the IPMA.

CADILLAC · 2025-03-19

This Preliminary information communicates a issue with the forward camera that causes a Forward Collision Unavailable Message With DTC U3000 SYM 45 or 54 due to a software anomaly and how to correct it.

CADILLAC · 2025-02-25

This Preliminary information communicates a issue with the forward camera that causes a Forward Collision Unavailable Message With DTC U3000 SYM 45 or 54 due to a software anomaly and how to correct it.

MAZDA · 2025-02-08

Some vehicle may experience the i-ACTIVSENSE/ALH warning lights on and a system error messages may be found in the center display as well. DTC U3000:04 (FSC) is stored in memory • DTC U3000:04 (FSC) - Forward sensing camera (FSC) internal malfunction • This may be caused by a hardware failure in an internal device of the FSC that results in the malfunction detection. To eliminate this concern, the production process of the FSC has been modified.

FORD · 2025-01-24

Some 2020-2024 Transit vehicles built on 01-Aug-2019 and through 23-Oct-2024 may exhibit a lack of power steering assist on initial engine start-up with diagnostic trouble code (DTC) U3000:49 stored in the power steering control module (PSCM).

CADILLAC · 2025-01-23

This Preliminary information communicates a issue with the forward camera that causes a Forward Collision Unavailable Message With DTC U3000 SYM 45 or 54 due to a software anomaly and how to correct it.