P0036 · Communications du constructeur

FORD · 2022-08-23

Some 2021-2022 Bronco Sport vehicles equipped with 2.0L engine may exhibit a malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P0036 and/or P0138 stored in the powertrain control module (PCM). This may be due to corrosion or water intrusion in connector C201 and/or C1570. Prior to performing Workshop Manual (WSM) diagnostics, inspect the male and female side of connector C201 and C1570 for signs of corrosion or water intrusion. If corrosion or water intrusion is found, replace connector C201 and/or C1570 with a pigtail kit and apply Motorcraft® Electrical Grease (XG-12) or equivalent.

FORD · 2022-08-03

Some 2022 Maverick vehicles built on or before 4-Apr-2022 equipped with 2.0L engine may exhibit a charging system warning indicator with diagnostic trouble codes (DTCs) U012D, U0284 and/or U042E stored in the powertrain control module (PCM). The vehicle may also exhibit a malfunction indicator lamp (MIL) with DTCs P0036:00 and/or P0138:00 stored in the PCM. This may be caused by water intrusion in the connector C1050. Prior to performing Workshop Manual (WSM) diagnostics, inspect the male and/or female connector C1050 for signs of corrosion or water intrusion. If water or corrosion is found, replace the male and/or female connector C1050 with a pigtail kit and apply electrical grease.

FORD · 2022-07-29

Some 2022 Maverick vehicles built on or before 4-Apr-2022 equipped with 2.0L engine may exhibit a charging system warning indicator with diagnostic trouble codes (DTCs) U012D, U0284 and/or U042E stored in the powertrain control module (PCM). The vehicle may also exhibit a malfunction indicator lamp (MIL) with DTCs P0036:00 and/or P0138:00 stored in the PCM. This may be caused by water intrusion in the connector C1050. Prior to performing Workshop Manual (WSM) diagnostics, inspect the male and/or female connector C1050 for signs of corrosion or water intrusion. If water or corrosion is found, replace the male and/or female connector C1050 with a pigtail kit and apply dielectric grease.

FORD · 2018-07-17

Some 2016-2018 Edge vehicles equipped with a 2.0L EcoBoost engine built on or before 12-Mar-2018 may exhibit an illuminated MIL with DTC P0036 stored in the powertrain control module (PCM). Follow the Service Procedure steps to correct the condition.

FORD · 2018-03-22

Some 2016-2017 Edge vehicles equipped with a 2.0L EcoBoost engine may exhibit an illuminated MIL with DTC P0036 stored in the powertrain control module (PCM). Follow the Service Procedure steps to correct the condition.

NISSAN · 2017-08-08

DTC P0036 DIAGNOSTIC INFORMATION This bulletin applies only to Altima and Pathfinder vehicles with a 6-cylinder engine. SERVICE INFORMATION The Electronic Service Manual (ESM) information for DTC P0036 may be inaccurate or incomplete for the Applied Vehicles. If an Applied Vehicle stores a DTC P0036, follow diagnostic procedures in the ESM for Bank 2 A/F Sensor Heater open or shorted.

INFINITI · 2017-08-08

DTC P0036 DIAGNOSTIC INFORMATION SERVICE INFORMATION The Electronic Service Manual (ESM) information for DTC P0036 may be inaccurate or incomplete for the Applied Vehicles. If an Applied Vehicle stores a DTC P0036, follow diagnostic procedures in the ESM for Bank 2 A/F Sensor Heater open or shorted.

JAGUAR · 2016-06-27

SITUATION: THE ENGINE MALFUNCTION INDICATOR LAMP (MIL) MAY BE ILLUMINATED. UPON DIAGNOSIS, THE TECHNICIAN MAY FIND DIAGNOSTIC TROUBLE CODES (DTC) RELEVANT TO THE MID-CATALYST AND POST-CATALYST HEATED OXYGEN SENSORS (HO2S) -- P0036, P0037, P0038, P0042, P0043, P0044, P0054, P0055, P0056, P0057, P0058, P0060, P0061, P0062, P0063, P0064, P0136, P013A, P013C, P013E, P0141 , P0141, P0142, P0143, P0144, P0147, P014A, P0156, P0157, P0158, P0161, P0162, P0163, P0164, AND/OR P0167 -- STORED IN THE POWERTRAIN CONTROL MODULE (PCM).

JAGUAR · 2015-10-29

"ISSUE: THE CUSTOMER MAY OBSERVE A MIL IN THE INSTRUMENT CLUSTER RELATING TO THE ENGINE SYSTEM (CHECK ENGINE LIGHT) AND ONE OR MORE CODES STORED IN THE PCM RELATING TO HEATED OXYGEN SENSOR (HO2S) IN THE EXHAUST SYSTEM. THE CODE WILL REFER TO A FAULT WITH THE PRE, OR MID, OR POST CATALYST HEATED OXYGEN SENSOR: P0036, P0037, P0038, P0054, P0136, P013A, P013E, P0141, P0042, P0043, P0044, P0055, P0142, P0143, P0144, P0147, P0056, P0057, P0058, P0060, P013C, P014A, P0156, P0157, P0158, P0161, P0062, P0063, P0064, P0162, P0163, P0164, P0167 UPON DIAGNOSIS NO FAULT IS FOUND WITH THE WIRING HARNESS OR CONNECTOR AND THE FAULT IS DETERMINED TO BE WITH THE SENSOR (HAVING FOLLOWED THE DIAGNOSTIC INFORMATION AND HELP TEXT RELATING TO PCM CODES AS READ BY SDD). CAUSE: THE ROOT CAUSE HAS YET TO BE…

JAGUAR · 2015-10-07

"SITUATION: THE ENGINE MALFUNCTION INDICATOR LAMP (MIL) MAY BE ILLUMINATED. UPON DIAGNOSIS, THE TECHNICIAN MAY FIND DIAGNOSTIC TROUBLE CODES (DTC) RELEVANT TO THE MID-CATALYST AND POST-CATALYST HEATED OXYGEN SENSORS (HO2S) -- P0036, P0037, P0038, P0042, P0043, P0044, P0054, P0055, P0056, P0057, P0058, P0060, P0061, P0062, P0063, P0064, P0136, P013A, P013C, P013E, P0141 , P0141, P0142, P0143, P0144, P0147, P014A, P0156, P0157, P0158, P0161, P0162, P0163, P0164, AND/OR P0167 -- STORED IN THE ENGINE CONTROL MODULE (ECM). CAUSE: THIS MAY BE CAUSED BY A POST-CATALYST HEATED OXYGEN SENSORS (HO2S) SOFTWARE ERROR."

FORD · 2015-05-18

FORD 2015 MUSTANG: BULLETIN INFORMATION INVOLVING VEHICLES EQUIPPED WITH A 2.3L ECOBOOST ENGINE AND BUILT BEFORE 12/19/2014 MAY EXHIBIT AN ILLUMINATED MIL WITH THE FOLLOWING DIAGNOSTIC TROUBLE CODES : P0036, P0054, P0137, AND /OR P0141. *LJ

BUICK, CHEVROLET, GMC · 2014-10-15

This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician may find a Diagnostic Trouble Codes P0030, P0031, P0032, P0036, P0037, P0038, P0050, P0051, P0052, P0053, P0054, P0056, P0057, P0058, P0059, P0060, P0131,?P0132,?P0134,?P0137,?P0138,?P0140,?P0151, P0052, P0154, P0157, P0158,?P0160, P0443, and P0049. Technician also may find Emission 1 Fuse is open. Technician will need to inspect and repair any wires damage on the engine harness to the Bank 1 O2 sensor for chafing on the A/C hose coupling.

DODGE · 2014-08-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor This bulletin involves the installation of an Oxygen (O2) Sensor Overlay Harness for any Oxygen Sensor related DTC(s). The Overlay Harness will consist of twelve 18 AWG wires (six from each Oxygen Sensor) that run to a new Oxygen Sensor Module connector. Four wires will be removed from the original vehicle O2 Module connector and installed in the new overlay harness O2 Module connector.Do NOT replace any parts prior to performing this bulletin and the Verifications test below. If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note). P013B O2 Sensor 1/2 Slow Response - Lean To Rich (Soot…

DODGE · 2013-03-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor inspecting for the part number of the transmission harness and based on the part number suffix, determining if the Oxygen Sensor Module Connector requires repair. Some model year 2011 harness' were built with tin plated terminals in 5 of the connector cavities that should have been gold plated. Based on the transmission harness part number, the terminals will be replaced as required.Service Bulletin's 25-004-12 and 18-012-12 REV. A (or later bulletins) must also be performed (if not previously performed). If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure BEFORE replacing any parts. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)…

DODGE · 2013-03-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor inspecting for the part number of the transmission harness and based on the part number suffix, determining if the Oxygen Sensor Module Connector requires repair. Some model year 2011 harness' were built with tin plated terminals in 5 of the connector cavities that should have been gold plated. Based on the transmission harness part number, the terminals will be replaced as required. Service Bulletin's 25-004-12 and 18-012-12 REV. A (or later bulletins) must also be performed (if not previously performed). If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure BEFORE replacing any parts. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)…

DODGE · 2013-03-01

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor inspecting for the part number of the transmission harness and based on the part number suffix, determining if the Oxygen Sensor Module Connector requires repair. Some model year 2011 harness' were built with tin plated terminals in 5 of the connector cavities that should have been gold plated. Based on the transmission harness part number, the terminals will be replaced as required.Service Bulletin's 25-004-12 and 18-012-12 REV. A (or later bulletins) must also be performed (if not previously performed). If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure BEFORE replacing any parts. P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)…

DODGE · 2012-12-18

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor This bulletin involves replacement of the Oxygen Sensor Connectors for any Oxygen Sensor related DTC. Do NOT replace any parts prior to performing this bulletin and the Verifications test below. If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure. ? P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note) ? P013B O2 Sensor 1/2 Slow Response - Lean To Rich (Soot related code, see note) ? P014C O2 Sensor 1/1 Slow Response - Rich To Lean (Soot related code, see note) ? P014D O2 Sensor 1/1 Slow Response - Lean To Rich (Soot related code, see note) ? P0030 O2 Sensor 1/1 Heater Circuit ? P0031 O2 Sensor 1/1 Heater Circuit Low ? P0032 O2 Sensor 1/1…

DODGE · 2012-12-18

Malfunction Indicator Lamp Illumination Due To Oxygen Sensor This bulletin involves replacement of the Oxygen Sensor Connectors for any Oxygen Sensor related DTC. Do NOT replace any parts prior to performing this bulletin and the Verifications test below. If the vehicle has any of the following DTC?s for O2 Sensors, Stored, Pending or Active, perform the Repair Procedure.? P013A O2 Sensor 1/2 Slow Response - Rich To Lean (Soot related code, see note)? P013B O2 Sensor 1/2 Slow Response - Lean To Rich (Soot related code, see note) ? P014C O2 Sensor 1/1 Slow Response - Rich To Lean (Soot related code, see note) ? P014D O2 Sensor 1/1 Slow Response - Lean To Rich (Soot related code, see note) ? P0030 O2 Sensor 1/1 Heater Circuit ? P0031 O2 Sensor 1/1 Heater Circuit Low ? P0032 O2 Sensor 1/1…

CADILLAC · 2003-11-18

SERVICE ENGINE SOON LIGHT ON WITH O2 SENSOR DIAGNOSTIC TROUBLE CODES (DTCS) P0138, P0151. *TT TO INCLUDE P0030, P0036, P0050, P0056. *TT

HUMMER ·

SES LIGHT AND REDUCED ENGINE POWER MESSAGE WITH DTCS P0030, P0036, P0135, P0141, P1682, AND P2101 - INSPECT POWERTRAIN RELAY OPERATION. *TT

CHEVROLET ·

CHECK ENGINE LIGHT (MIL) ON. THE ENGINE MAY NOT CRANK OVER. DIAGNOSTIC TROUBLE CODES P0443, P0102, P0036, P0030, P0135, P0101 MAY BE SET. *TT